N-0155
STEP 1:
String a mahogany with shell pendant (SP1354RSN-SMGY) with two jump rings (FMRJ6G-144). Close the rings. Set aside.
STEP 2:
On one end of a 26in. beadalon wire (BC07-021BT-30), string a crimp bead followed by (FMCRBD2G-144) a split ring (FMRS5S-144). Make sure the end of the beadalon wire is strung back through the crimp bead. Crimp the crimp bead.
STEP 3:
Following the same order, string one piece painted wood (WDP1320AP) and one piece red coco heishi (COS1403R) until you reach the eight coco heishi piece.
STEP 4:
Thread a painted wood bead (WDP2125AP2) followed by a graywood bead (WD1305G), split rings and another graywood bead (WD1305G). Repeat the same procedure until you reach the eight painted wood bead (WDP2125AP2).
STEP 5:
Repeat step three in reverse process.
STEP 6:
Locate the fourth split ring and make it the center of the necklace. Grab the pendant. Open two jump rings and slide it through the split rings and through the rings on the pendant. Close the jump rings.
STEP 7:
Repeat step two. Continue passing the end of the wire back through the last painted wood bead.
STEP 8:
Trim off excess wire.
STEP 9:
On the right end of this necklace, connect the split rings and the toggle bar (FMCLTOG9G-144) with two oval jump rings (FMRJ3G-144).
STEP 10:
To finish off this project, repeat step nine & substitute the toggle bar with toggle ring (FMCLTOG9G-144) and one oval jump ring.
List of Materials:
1pc. SP1354RSN-SMGY mahogany with shell inlay pendant 54mm
8pcs. WDP2125AP2 painted wood oval 17x25mm
16pcs. WDP1320AP painted wood round 15mm
1strand COS1403R coco heishi 2-3mm red
14pcs. WD1305G gray wood beads 4-5mm
26in. BC07-021BT-30 beadalon wire 9pcs. FMRS5S-144 split rings
6pcs. FMGPPH028x2-72 head pins gold plated 2″
7pcs. FMRJ6G-144 open jump ring gold plated 6mm
1pair FMCLTOG9G-144 toggle clasps gold plated 9mm
2pcs. FMCRBD2G-144 crimp beads
3pcs. FMRJ3G-144 oval jump ring gold plated 3x4mm