N-0012
STEP 1:
Prepare a 7 pieces sunflower wood (WDS5440P). Attach an open jump ring (FMRJ8S-144) on each sunflower wood’s hole. Make six bead link units. Set aside.
STEP 2:
On the remaining piece of sunflower wood, on one hole attach two pieces open jump ring (FMRJ8S) and one piece on the other hole. This would be the center piece.
STEP 3:
Grab one of the two pieces jump ring (FMRJ8S-144) on the center piece. Attach it to the first bead link unit using two jump rings (FMRJ4S-144).
STEP 4:
Attach the second bead link unit using a jump ring. Do the same on the third link unit.
STEP 5:
On the third bead link unit open the jump ring (FMRJ8S-144). Attach a cord end cap (FMCE18S-144). Set aside.
STEP 6:
Cut a 5 and ½ in. leather cord (BCLG15BK-5).
STEP 7:
Put a drop of hypo cement (TLGSHYPO01) on one end. Insert onto the cord end cap. Let it dry.
STEP 8:
Repeat step seven on the other end.
STEP 9:
Attach a six pieces open jump ring (FMRJ6S) onto the cord end.
STEP 10:
On a head pin (SFPH020x15-100), string a salwag bead (SLG1906P). Make the first half of the wrapped loop, attach to the sixth open jump ring. Finish the wraps. Cut excess wire off. Left neckline is now finished.
STEP 11:
On the right neckline, repeat steps four up to ten. Substitute the five pieces open jump ring and the salwag bead just strung with a lobster clasp (FMCLLXSMS).
STEP 12:
String a salwag bead onto a head pin, make a wrapped loop. Trim off excess wire. Attach to the jump ring (FMRJ8S-144) at the bottom of the center piece using a jump ring (FMRJ4S-144). You have a piece of jewelry finished.
List of Materials:
7 pcs. WDS5440P sunflower wood 54x40x3.5mm pink
2 pcs. SLG1906P pink salwag round beads
15 pcs. FMRJ8S open ring
7 pcs. FMRJ6S open ring
9 pcs. FMRJ4S open ring 1 pc. FMCLLXSMS silver platedlobster clasps extra small
2 pcs. 5.5in. BCLG15BK-5 black greek leather cord
4 pcs. FMCE18S-144 silver plated tube cord end caps
2 pcs. SFPH020x15-100 silver filled head pins
1 tube TLGSHYPO01 g/s hypo cement