String a mahogany with shell pendant (SP1354RSN-SMGY) with two jump rings (FMRJ6G-144). Close the rings. Set aside.
On one end of a 26in. beadalon wire (BC07-021BT-30), string a crimp bead
followed by (FMCRBD2G-144) a split ring (FMRS5S-144). Make sure the end of the beadalon wire is strung back through the crimp bead. Crimp the crimp bead.
Following the same order, string one piece painted wood (WDP1320AP) and one piece red coco heishi (COS1403R) until you reach the eight coco heishi piece.
Thread a painted wood bead (WDP2125AP2) followed by a graywood bead (WD1305G), split rings and another graywood bead (WD1305G). Repeat the same procedure until you reach the eight painted wood bead (WDP2125AP2).
Repeat step three in reverse process.
Locate the fourth split ring and make it the center of the necklace. Grab the pendant. Open two jump rings and slide it through the split rings and through the rings on the pendant. Close the jump rings.
Repeat step two. Continue passing the end of the wire back through the last painted wood bead.
Trim off excess wire.
On the right end of this necklace, connect the split rings and the toggle bar
(FMCLTOG9G-144) with two oval jump rings (FMRJ3G-144).
List of Materials:
To finish off this project, repeat step nine & substitute the toggle bar with toggle ring (FMCLTOG9G-144) and one oval jump ring.
1pc. SP1354RSN-SMGY mahogany with shell pendant
8pcs. WDP2125AP2 painted wood
16pcs. WDP1320AP painted wood
1strand COS1403R coco heishi
14pcs. WD1305G wood beads
26in. BC07-021BT-30 beadalon wire
9pcs. FMRS5S-144 split rings
6pcs. FMGPPH028x2-72 head pins
7pcs. FMRJ6G-144 open jump ring
1pair FMCLTOG9G-144 toggle clasps
2pcs. FMCRBD2G-144 crimp beads
3pcs. FMRJ3G-144 oval jump ring